Software downloads

Please note that in order to run the software you need valid license keys for both the inLab CAD SW 22 as well as for the Basis module. Licenses can be ordered from your Dentsply Sirona Dealer.

inLab CAM SW 22.3 requires the inLab CAM SW 22 license. Without an inLab CAM SW 22 license, the Software will start in a demo mode that allows for using and testing the software but will not allow for production. inLab CAM 22.x uses CAM Service as database for all manufacturing data such as designs and blanks. IMPORTANT: inLab CAM 22 will import all *.cam (designs) and *.blc (blanks/jobs) data into the CAM Service database. Once the data is imported, it will no longer be accessible with inLab CAM ≤20.x! Please make sure, that you have the appropriate licenses installed and/or backup your data if you intend to further use the data with inLab CAM ≤20.x!

Minimum requirement is an installed inLab CAD SW 22.1.x as well as license keys for both the inLab CAD SW 22 and for the Basis module.

Minimum requirement is an installed inLab CAD SW 22.1.x as well as license keys for the inLab CAD SW 22, for the Basis module and for the Removables module.

Minimum requirement is an installed inLab CAD SW 22.1.x as well as license keys for the inLab CAD SW 22, for the Basis module and for the Removables module.

The update CEREC SW 5.2.9 is distributed via AutoUpdate. The update requires a pre-installed CEREC SW 5.2.8.

De update van CEREC SW 5.2.8 wordt ook gedistribueerd via AutoUpdate.

The update CEREC SW 5.2.4 is also distributed via AutoUpdate.

The update CEREC SW 5.2.3 is also distributed via AutoUpdate.

Connect SW 5.2.7 Software Update

Connect SW 5.2.6 Software Update

Connect SW 5.2.4 Update

Connect SW 5.2.3 Update

Connect SW 5.2.2 Update

Connect your Connect SW, CEREC SW, inLab CAD SW, inLab CAM SW to DS Core